RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 79)

Installation and Operation Manual Chapter 3 Operation

Egate-100 Ver. 4.0 Configuration and Management Alternatives 3-5

3.4 Configuration and Management Alternatives

You can manage and configure Egate-100 using out-of band management or

inband management interfaces. Refer to the respective section for further

information and instructions:

•

Working with Terminal

•

Working with the Web-Based Management Application

Working with Terminal

You can connect an ASCII terminal directly to the Egate-100 control port.

Any standard ASCII terminal, dumb terminal, or a PC running a terminal emulation

application equipped with a V.24/RS-232 communication interface can be used to

set up and configure Egate-100.

³ To connect Egate-100 to a control terminal:

1. Make sure that all Egate-100 cables and connectors are properly connected.

2. Connect Egate-100 to a PC equipped with an ASCII terminal emulation

application such as HyperTerminal or Procomm.

3. Connect an ASCII terminal to the CONTROL port on the front panel. The

default settings are as follows:

 Baud Rate: 115,200 bps

 Data Bits: 8

 Parity: None

 Stop Bits: 1

 Flow Control: None.

4. To optimize the view of the system menus, do the following:

 Set the terminal emulator to VT100.

 If you are using HyperTerminal, set the terminal mode to 132-column

mode.

5. Power up Egate-100.

When the unit has initialized and completed the self-test, a menu

appears displaying initialization and self-test results. When the self test

has been successfully completed, the RDY LED on the front panel turns

green.

To access the main menu, you have to log in first.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 79