RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 115)

Installation and Operation Manual Chapter 4 Configuration

Egate-100 Ver. 4.0 Configuring Egate-100 for Management 4-23

³ To remove a user:

1. Select the desired user and type R.

You are asked to confirm or reject your selection.

2. Type Y or N to confirm or reject the selection.

³ To remove all users:

1. In the User Information menu, type C.

You are asked to confirm or reject your selection.

2. Type Y or N to confirm or reject the request.

If confirmed, all added users are removed. The default users remain in the

system.

If you are logged on as user or with a user name associated with user privileges,

you are unable to add or remove users.

Egate-100 allows you to change the password for both the read-only user and

the super user. In case you forget your user password, you can obtain a new one.

³ To change a password

• Refer to

Configuring User

for instructions.

³ To obtain a new password:

1. Log in with the username CHNGPASS.

An ID number (Dynamic Key) appears at the bottom of the menu.

2. Contact RAD Technical Support and refer to this key.

You will receive a temporary password.

3. Log in using the temporary password.

You will be prompted to enter and confirm a new password for future

sessions.

Configuring Network Managers

You can define or modify the network management stations to which the

Egate-100 SNMP agent sends traps. Up to 16 managers can be defined. In

addition, you can temporarily prevent a manager station from receiving traps by

masking the network manager.

³ To add a network manager:

1. From the Management menu, select Manager List.

The Manager List menu appears as illustrated in

Figure

4-21

2. Enter a sequential number, corresponding to the manager you wish to

specify.

3. Specify IP Address and Trap (masked/unmasked).

Note

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 115