RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 69)

Installation and Operation Manual Chapter 2 Installation and Setup

Egate-100 Ver. 4.0 Installing Fiber Optic SFP Modules 2-3

2.4 Mounting the Unit

Egate-100 is designed for installation as a desktop unit or mounted in a rack.

• For rack-mounting instructions, refer to the installation kit manual.

• If Egate-100 is to be used as a desktop unit, place and secure the unit on a

stable, non-movable surface.

Refer to the clearance and temperature requirements in

Site Requirements and

Prerequisites.

2.5 Installing Fiber Optic SFP Modules

Egate-100 uses SFP modules with LC fiber optic connectors that provide

hot-swappable industry-standard interfaces.

Third-party SFP optical transceivers must be agency-approved, complying with the

local laser safety regulations for Class 1 laser equipment.

³ To install the SFP modules:

1. Lock the wire latch of each SFP module by lifting it up until it clicks into place,

as illustrated in

Figure

2-1.

Some SFP models have a plastic door instead of a wire latch.

Figure

2-1. Locking the SFP Wire Latch

2. Carefully remove the dust covers from the SFP slot.

3. Insert the rear end of SFP into the socket, and push slowly backwards to

mate the connectors until the SFP clicks into place. If you feel resistance

before the connectors are fully mated, retract the SFP using the latch wire as

a pulling handle, and then repeat the procedure.

4. Remove the protective rubber caps from the SFP modules.

Note

Warning

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 69