RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 59)

Installation and Operation Manual Chapter 1 Introduction

Egate-100 Ver. 4.0 Functional Description 1-27

For out-of-band management, the second Gigabit Ethernet port can be used to

connect to the management network. If you use the second Gigabit Ethernet port

for management, it is recommended to operate the port at 100Mbps to minimize

the impact of management traffic bursts on Gigabit Ethernet user traffic.

Security

ASCII terminal, Telnet, and Web access are password protected. After a period of

15 minutes of inactivity during which no character was sent to the terminal, the

system exits to the password screen and the Telnet or Web session is closed.

Egate-100 supports the following access authorization levels and mechanisms:

• Superuser mode for configuration and monitoring

• User mode for monitoring and configuration view only

• Radius support for password authentication and management.

Egate-100 also supports secured Telnet and Web access using SSL/SSH. The

security level is user-configurable:

• Access enabled

• Secured access (SSL/SSH only)

• Managers only (access allowed only for stations on the Manager List)

• Access disabled (no access to Telnet or Web).

Management Access

Egate-100 architecture allows access from the Gigabit Ethernet network port to

the Egate-100 host and remote site devices. In VLAN-aware mode, separation of

management traffic from user traffic can be achieved by use of different VLANs.

In the scenario illustrated by

Figure

1-16

, traffic coming from the remote CPE

uses separate VLANs for user and management traffic. Each remote uses two

VLANS, one for user traffic, for which the CPE can use tag stacking, and the other

for management traffic. All CPEs connected to Egate-100 share the same

management VLAN.

Note

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 59