RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 108)

Chapter 4 Configuration Installation and Operation Manual

4-16 Configuring Egate-100 for Management Egate-100 Ver. 4.0

 Type F (Forward) or B (Back) to select a notification entry.

 Type R (Remove) to delete the selected entry.

Configuring Target Parameters

Target is an SNMPv3 network management station to which Egate-100 is going to

send trap notifications. A set of parameters has to be configured and assigned to

each target.

³ To configure target parameters:

1. From the Targets & Notify menu (Configuration > System > Management >

SNMPv3 Settings > Targets & Notify), select Target Params.

The Target Params menu is displayed as illustrated in

Figure

4-14

2. From the Target Params menu, configure the following:

 Name (An ASCII string identifying current set of target parameters)

 Message Processing Model (The Message Processing Model to be used

when generating SNMP messages using this entry):

 SNMPv1

 SNMPv2c

 SNMPv2u

 SNMPv3

 Security Model (The Security Model to be used when generating SNMP

messages using this entry):

 Any

 SNMPv1

 SNMPv2c

 User-Based Security Model (USM)

 Not defined

 Security Name (Identification of the principal on whose behalf SNMP

messages are to be generated using this entry. This can be either

SNMPv3 user or SNMPv1/SNMPv2 community string.)

 Security Level (The level of security to be used when generating SNMP

messages using this entry):

 noAuthNoPriv (Authorization and privacy are disabled)

 authNoPriv (Authorization is enabled, privacy is disabled)

 authPriv (Authorization and privacy are enabled)

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 108