RAD Data comm 100 Spezifikationen PDF herunterladen (Seite 155)

Installation and Operation Manual Chapter 4 Configuration

Egate-100 Ver. 4.0 Configuring Egate-100 for Operation 4-63

Table

4-28. Service Virtual Interface Parameters

Parameter Description Possible Values

Port Number Defines the egress port

number

Default: 1

1-2

Port Name Defines the port name SVI-1

SVI-2

Configuring the Bridge

The configuration of the Egate-100 internal bridge involves setting global

parameters for the bridge (VLAN-Aware/Unaware, aging, VLAN identification, and

VLAN loop detection) and assigning and configuring bridge ports. Configuration of

the bridge is performed via the Applications menu.

If the application is set to Flows Support, the bridge parameters are

inaccessible. For information about configuring Flow Support, see

Quick Start

Guide

In order to change a bridge from VLAN-aware to VLAN-unaware (or from

VLAN-unaware to VLAN-aware), you have to first remove any defined bridge

ports. After changing the bridge mode, you have to reset the device.

For a detailed explanation of Egate-100’s bridge, refer to

Chapter 1

. For

information on configuration parameters, refer to

Table

4-29

³ To configure the internal bridge:

1. Navigate to Main Menu > Configuration > Applications > Bridge.

The Bridge menu appears as illustrated in

Figure

4-63

2. From the Bridge menu, configure the parameters as specified in

Table

4-29

3. If you set the bridge to VLAN-aware mode, define VLAN Membership as

described in

Configuring VLAN Membership

Note

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 317 318

Keine Kommentare

RAD Data comm 100 Spezifikationen Seite 155