RAD Data comm ASMI-450 Bedienungsanleitung PDF herunterladen (Seite 84)

Chapter 4 Configuring a Typical Application User's Manual

4-2 HDSL Applications LRS-24 RADview/TDM

HTU-2

LAN

LRS-24

HTU-E1C

4-wire

RADview

Management

Station

Central Site Remote Site

Network

Figure 4-1. HDSL Application

HDSL Configuration

The recommended HDSL configuration procedure of the local and remote (SMOD)

units includes the following steps:

1. 1. Performing preliminary configuration of LRS-24 via ASCII terminal (setting

IP parameters), see page

4-2

2. Configuring remote HTU-2, see page

4-3

3. Configuring HTU-E1C and HTU-2 via RADview (see page

4-3

 Entering IP address of the RADview management station

 Masking/unmasking remote traps

 Configuring system parameters of HTU-E1C

 Configuring the clock mode of HTU-E1C

 Assigning HTU-2 timeslots.

4. Connecting the DTEs to both modems, see page

4-8

Performing Preliminary LRS-24 Configuration

 To perform preliminary LRS-24 configuration:

1. Connect an ASCII terminal to the RS-232 port of LRS-24.

2. Assign an IP address to LRS-24.

3. Set read, trap and read/write communities to public.

4. Set the hub IP mode to multiple.

5. Reset LRS-24 by powering it off and back on again. Another option is to take

out and re-insert the CM-2 card.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 159 160

Keine Kommentare

RAD Data comm ASMI-450 Bedienungsanleitung Seite 84