RAD Data comm ASMI-450 Bedienungsanleitung PDF herunterladen (Seite 59)

User's Manual Chapter 3 Configuration Management

LRS-24 RADview/TDM Setting Operational Parameters 3-37

Table 3-13. ASM-40CD Ports Configuration Parameters

Parameter Possible Values / Remarks

DTE

Interface Type (IR) V.24, RS-530, X.21, V.35, ETH/ UTP, ETH/ BNC, G.703 (64K), HDB3

Read-only

Rate (Kbps) 32, 64, 128, 192, 256, 384, 512, 768, 1024, 1536, 1544, 1920, 2048

Disabled if Local-Ext-Auto; Remote-Rev is displayed in the Clock source field

Err Correction Off, On-Random, On-Burst

Disabled if Not Applicable received from agent

Disabled if rate is greater than 1024

Phantom Disable, Enable (when checked)

If the input impedance is 75 and phantom is enabled this field should not be checked.

DTE Cont...

RLB Enable Disable, Enable (when checked)

LLB Enable Disable, Enable (when checked)

Line

Clock Source Clock Source is read-only for the far-end modem

Local-Int; Remote-Rcv

Local-Rcv; Remote-Int

Local-Ext-Auto; Remote-RcvN/A for Ethernet and ETH/BNC

Input Impedance 75,100,120

The selectable values are 75, 120 if the rate (kbps) is divisible by 64 (Rate = n×64).

The selectable value are 100 if the rate (kbps) is divisible by 56 (rate = n×56).

Otherwise, the selectable values are 75, 100, 120.

Carrier Control Disable, Enable (when checked)

Line Code AMI, HDB3, B8ZS

The selectable value are HDB3 if the rate (kbps) is divisible by 64 (Rate = n×64).

The selectable value are AMI and B8ZS if the rate (kbps) is divisible by 56 (Rate = n×56).

Otherwise the selectable values are AMI, HDB3, B8ZS

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 159 160

Keine Kommentare

RAD Data comm ASMI-450 Bedienungsanleitung Seite 59