RAD Data comm ASMI-450 Bedienungsanleitung PDF herunterladen (Seite 55)

User's Manual Chapter 3 Configuration Management

LRS-24 RADview/TDM Setting Operational Parameters 3-33

Table 3-11. ASMi-31C Port Configuration Parameters

Parameter Possible Values / Remarks

DTE

Interface Type (IR) V.24, RS-530, X.21, G.703, V.35, G.703 (64K), No IR, ETH/BNC, ETH/UTP

Read-only

Protocol Sync, Async

Data Bits 5, 6, 7, 8

Enabled if Protocol=Async

Stop Bits 1, 2

Enabled if Protocol=Async

Parity None, Odd, Even

Enabled if Protocol=Async

Rate (kbps) For Protocol = Sync:

64, 128 (when far-end modem is ASMi-31 and near-end modem is ASMi-31CQ)

1.2, 2.4, 4.8, 9.6, 16, 19.2, 32, 38.4, 48.0, 56, 64.0, 128

For Protocol = Async:

1.2, 2.4, 4.8, 9.6, 19.2, 38.4, 57.6, 115.2

57.6 and 115.2 are available only for versions > 0.1.

DTE Cont...

RLB Enable Disable, Enable (when checked)

Disabled if the interface type is X.21, G.703, (64k), Ethernet, and ETH/BNC.

LLB Enable Disable, Enable (when checked)

Disabled if the interface type is X.21, G.703, (64k), Ethernet, and ETH/BNC.

RTS-DCD Enable Disable, Enable (when checked)

DTR-DSR Enable Disable, Enable (when checked)

Line

Clock Source Read-only for the far-end modem for software version less than 1.00; otherwise, it is

Read/Write.

For DTE1 Protocol = Sync:

For software versions less than 1.00

Local-Ext; Remote-Rcv

N/A with Ethernet and ETH/BNC

Local-Int; Remote-Rcv

Local-Rcv; Remote-Int

Local-Rcv; Remote-Ext

For software versions less than 1.00

N/A with Ethernet and ETH/BNC

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 159 160

Keine Kommentare

RAD Data comm ASMI-450 Bedienungsanleitung Seite 55