RAD Data comm ASMI-450 Bedienungsanleitung PDF herunterladen (Seite 92)

Chapter 4 RADview-HPOV System Functions RADview-HPOV/ATM User’s Manual

4-34 TFTP File Transfer



To perform TFTP File Transfer Operations:

1. Perform one of the following:

 Highlight the specific nodes from the list on which you want to perform

TFTP File Transfer (press Shift for several nodes).

 Press <All Nodes Operation>

 Press <Selected Nodes Operation>. This can be used in case of TFTP

failure. Select only those nodes where the transfer of new software was not

successful, according to "Last Status" column, and reinitialize TFTP session.

2. If using Selected Nodes (see Figure 4-29), select any TFTP File Transfer

Operation. Only options that are supported by all Nodes of the list are

selectable (see Figure 4-30).

3. Press <Set>.

A confirmation message appears (see Figure 4-31).

4. Press <OK>.

5. Look at the status reported on the Last Status column (see Figure 4-25) to

check whether the download was successful. Additional information is

available via the Report Tab.

In order to upgrade SW, agent should perform Reboot after the SW was

downloaded to Agent. In some cases, user may want the device to Reboot (Reset)

only on a specific time. Therefore, as relevant, user can select an Operation that

includes Download Only for file download only, an Operation that includes

"Download & Reboot" for complete software upgrade or an Operation of Reset

Only for rebooting at a specific time after having successfully downloaded the

software.

When Operation selected in Operation TAB, [All Nodes Operation...] or [Selected

Nodes Operation...] includes Download & Reboot, NMS will perform the

operations mentioned in Table 4-8.

Note

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 165 166

Keine Kommentare

RAD Data comm ASMI-450 Bedienungsanleitung Seite 92