RAD Data comm ASMI-450 Bedienungsanleitung PDF herunterladen (Seite 121)

RADview-HPOV/ATM User’s Manual Chapter 4 RADview-HPOV System Functions

Automatic Configuration Upload 4-63

Selecting Nodes

You can select which agent configurations will be updated by:

• Agent type (ACE-101, ACE-50, ACE-2002, IPmux-1/1E, IPmux-4, IPmux-16)

• Node (IP Address).

Adding/Removing Nodes



To Add/Remove nodes to ACU list:

1. From the Options menu, select Nodes Selection.

The Automatic Configuration Upload Nodes Selection dialog box appears

(see Figure 4-58).

2. Press <Node Selection> for an agent type.

The ACU application checks the database for all nodes of that agent type.

The Node Selection dialog box for a specific agent type appears, showing

IP Addresses for all nodes of that agent type, in two columns (see

Figure 4-59). You can move nodes from one column to the other by the

<Add> or <Remove> button. The nodes that appear in these lists are

only of the agent type in the row that was pressed in the previous dialog

box.

 Remaining Nodes are those nodes from HPOV that are not in the ACU

database (not scheduled for ACU).

 Selected Nodes are those nodes from HPOV that are in the ACU

database (scheduled for ACU).

3. Perform one of the following (see Figure 4-59):

 Check <All> for all remaining nodes of an agent

 Check <Selected> if you want to make any changes, i.e. to add or

remove nodes from the list that will be uploaded in the next session.

4. Highlight a node and press <Add> or <Remove>.

The node(s) moves to the opposite column.

5. Press <Set>.

The Automatic Configuration Upload Nodes Selection dialog box appears

(see Figure 4-58).

6. Click on the checkbox for each agent where you want to apply ACU and

press <Apply>.

The Status bar on the bottom of the dialog box says “DB Set successful”.

7. Press <All Nodes> to verify that you have selected the correct node name (IP

Address) and agent type.

The All Agents dialog box appears (see Figure 4-60). Only those nodes that

have Yes in the Uploaded column will be updated in the next scheduled

ACU operation. They are highlighted in green.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 165 166

Keine Kommentare

RAD Data comm ASMI-450 Bedienungsanleitung Seite 121