RAD Data comm E1 Interface Converter RIC-E1 Spezifikationen Seite 59
- Seite / 94
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
RIC-E1 Installation and Operation Manual Appendix D IR-IP Interface Module
IR-IP Management Subsystem, General D-5
Table D-3. IR-IP Controls
Control
RIC-E1 RIC-E1/R
Function Values
Default
Setting
DIP switch,
section 1
IP LEARN pushbutton,
DIP switch, section 5
Enables IR-IP to learn its IP ON – IP address learning is enabled
OFF – IP address learning is disabled
OFF
Note: IP LEARN pushbutton settings override settings of the DIP switch.
DIP switch,
section 2
DIP switch, section 4 Selects the WAN protocol ON – PPP protocol
OFF – Frame Relay protocol
OFF
DIP switch,
section 3
DIP switch, section 3 Selects the LAN mode ON – Full duplex operation
OFF – Half duplex operation
OFF
DIP switch,
section 4
DIP switch, section 2 Controls the remote WAN test
loopback, which returns packets
received from the WAN back toward
the WAN
ON – The test loopback is activated
OFF – The test loopback is disabled
OFF
– DIP switch, section 6 Allows the user to operate the
module in case the IP address and/or
Telnet password are lost
ON – Forces default IP password
and/or no password protection
OFF – IR-IP operates according to
user configuration
OFF
– DIP switch, section 1 Not in use – –
When using the IP LEARN pushbutton for the IP address configuration, make sure
that the PNL SW jumper (JP5) on the RIC-E1/R PCB is set to EN.
Table D-4 provides the pinout of the IR-IP RJ-45 connector.
Table D-4. RJ-45 Pinout
Pin Name Function
1 TD (+) Transmit data positive
2 TD (-) Transmit data negative
3 RD (+) Receive data positive
6 RD (-) Receive data negative
D.4 IR-IP Management Subsystem, General
The IR-IP interface module management subsystem supports the following
functions:
• Preliminary configuration
• Configuration of management access parameters
• Advanced configuration of IR-IP parameters
• Collection and display of statistical performance data
• Maintenance functions, which include:
Software downloading
Note
- E1 Interface Converter 1
- Limited Warranty 4
- General Safety Instructions 5
- Handling Energized Products 6
- FCC-15 User Information 8
- Declaration of Conformity 10
- Quick Start Guide 11
- 2. Operating RIC-E1 12
- Contents 13
- List of Figures 14
- List of Tables 14
- Chapter 1 15
- Introduction 15
- 1.2 Physical Description 16
- 1.3 Functional Description 17
- 1.4 Technical Specifications 18
- Chapter 2 21
- Installation and Setup 21
- 2.3 Configuring RIC-E1 22
- Configuring RIC-E1 2-3 23
- Connecting the Interfaces 24
- Connecting the Power 25
- 2-6 Configuring RIC-E1 26
- Chapter 3 27
- Operation 27
- 3.2 Operating Instructions 28
- Chapter 4 29
- Troubleshooting and 29
- Diagnostics 29
- 4.2 Troubleshooting 30
- Chapter 5 31
- RIC-E1/R Card 31
- 5-2 ASM-MN-214 Card Cage 32
- 5.2 Power Supply 33
- 5.3 RIC-E1/R Front Panel 34
- CHASS-GND 36
- TX&RX CODE 36
- TIMING SEL 36
- Warning 38
- Appendix A 39
- Interface Connector Wiring 39
- [Function] 40
- [Signal 40
- Timing] 40
- A.3 Line Interface Connector 41
- Appendix B 43
- IR-ETH Interface Module 43
- 10BA SE-T 43
- B.2 Technical Specifications 45
- Setting the DIP Switch 46
- LED Indicators 46
- Connecting the LAN 47
- C.1 IR-ETH/QN Options 49
- C.2 Technical Specifications 51
- Setting the DIP Switches 52
- Appendix D 55
- IR-IP Interface Module 55
- D.2 Technical Specifications 56
- D.3 Physical Description 56
- RIC-E1/IP 57
- IR-IP LEDs 58
- IR-IP Controls 58
- Rescue Configuration 61
- Connecting the Telnet Host 62
- What to Do If 64
- D.6 IR-IP Management Utility 65
- D.7 Quick Setup Menu 66
- LAN IP Address 67
- LAN IP Mask 67
- WAN IP Address 67
- WAN IP Mask 67
- Default Gateway 67
- RIC-E1 with IR-IP 68
- DHCP Server 68
- LAN IP Address: 192.168.1.2 68
- Mask: 255.255.255.248 68
- IP Network 68
- D.8 Management Access Menu 69
- D.9 Advanced Setup Menu 70
- Interface Parameters Menu 71
- D-18 Advanced Setup Menu 72
- Protocol Field Compression 73
- Authentication Protocol 73
- Multicast IP Menu 74
- Multicast Forwarding 75
- D.10 Device Control Menu 76
- New Software Download Menu 77
- Viewing Error Log Screen 77
- Erasing Configuration 78
- Resets Menu 78
- D.11 View Menu 79
- ARP Tables 80
- Statistics Screen 81
- Using the Ping Function 83
- D.14 Erasing IR-IP Software 84
- Erasing Application Software 85
- Downloading New Software 85
- E.1 Introduction 87
- EXT INT/LBT 88
- INT/LBT Clock Mode 89
- Customer Response Form 91
- Error Report 92
Verwandte Produkte und Handbücher für Vernetzung RAD Data comm E1 Interface Converter RIC-E1
Vernetzung RAD Data comm 100 Spezifikationen
(318 Seiten)
(318 Seiten)
Vernetzung RAD Data comm ASMi-52L Spezifikationen
(153 Seiten)
(153 Seiten)
Vernetzung RAD Data comm T1 Spezifikationen
(48 Seiten)
(48 Seiten)
Vernetzung RAD Data comm HCD-E1 Spezifikationen
(150 Seiten)
(150 Seiten)
Vernetzung RAD Data comm MiRICi-E3T3 Spezifikationen
(106 Seiten)
(106 Seiten)
Vernetzung RAD Data comm 100 Spezifikationen
(9 Seiten)
(9 Seiten)
Vernetzung RAD Data comm ASM-60 Spezifikationen
(90 Seiten)
(90 Seiten)
Vernetzung RAD Data comm ASMi-52CQ Spezifikationen
(100 Seiten)
(100 Seiten)
Vernetzung RAD Data comm FOM-E3 Bedienerhandbuch
(33 Seiten)
(33 Seiten)
Vernetzung RAD Data comm 146 Bedienungsanleitung
(202 Seiten)
(202 Seiten)
Vernetzung RAD Data comm LA-210 Spezifikationen
(210 Seiten)
(210 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.403 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern