RAD Data comm FCD-V35 Spezifikationen Seite 44
- Seite / 228
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Chapter 1 Introduction Installation and Operation Manual
1-24 Technical Specifications FCD-E1LC Ver. 1.0
Table
1-3. Handling of Management Access Conflicts
Type of First Response to Second Access
Access
Telnet Inband Telnet
Out-of-Band
Supervision
Terminal
Telnet Inband Message Ignored Message
Telnet
Out-of-Band
Message Ignored Ignored
Supervision
Terminal
Disconnects
the terminal
Not possible Ignored
1.7 Technical Specifications
E1 Main and
Sublinks
Compliance
ITU-T Rec. G.703, G.704, G.706, G.732, G.826
Framing
• G732N, 2 frames per multiframe, CRC-4
option disabled
• G732N, 2 frames per multiframe, CRC-4
option enabled
• G732S, 16 frames per multiframe, CRC-4
option disabled
• G732S, 16 frames per multiframe, CRC-4
option enabled
• Unframed
Data Rate
2.048 Mbps (±50ppm)
Line Code
HDB3
Interface Type Balanced or unbalanced, with automatic
selection in accordance with the connected
cable
Line Impedance
Balanced interface
120Ω
Unbalanced interface
75Ω
Transmit level
Balanced Interface
±3V ±10%
Unbalanced Interface
±2.37V ±10%
- FCD-E1LC 1
- Limited Warranty 4
- Product Disposal 4
- General Safety Instructions 5
- Safety Symbols 5
- Handling Energized Products 6
- Caution 8
- Attention 8
- FCC-15 User Information 9
- Mise au rebut du produit 10
- Symboles de sécurité 10
- Français 11
- Declaration of Conformity 13
- Quick Start Guide 15
- 3. Cable Connections 16
- Configuration Procedure 17
- Contents 19
- Chapter 1 21
- Introduction 21
- Main Features 22
- 1.2 Typical Applications 23
- 1.3 Physical Description 24
- 1.4 Functional Description 25
- Internal Bus Functions 27
- Main Link Interface 28
- Sublink Interface 29
- Synchronous Data Channels 30
- Ethernet Interface 31
- Ethernet Switch Description 32
- Flow Control Options 32
- Forwarding Algorithms 33
- VLAN and QoS Support 33
- System Timing 34
- Main Link Timing 34
- Sublink Timing 34
- Diagnostics 35
- Timeslot Handling 36
- Management Subsystem 36
- Power Supply Subsystem 38
- 1.5 Timing Considerations 39
- System Management Method 40
- Management Access Options 41
- Serial Ports 42
- MBE/RAS/A 42
- Diagnostics 48
- Indicators 48
- Chapter 2 51
- Installation and Setup 51
- Physical Requirements 53
- Power Requirements 53
- Connections 53
- Serial Data Port Connections 54
- Ethernet Port Connections 54
- 2.3 Package Contents 55
- 2.4 Equipment Needed 56
- 2.5 FCD-E1LC Enclosures 56
- FCD-E1LC Rear Panels 57
- Opening the Unit 60
- Figure 2-4 61
- Figure 2-5 61
- 1. Refer to 62
- Table 2-4 63
- Closing the Unit 64
- 2.7 Connecting the Cables 65
- Connecting the Sublink 66
- Connecting the Data Channels 66
- Connecting Ethernet 66
- 2.8 Connecting to Power 67
- Chapter 3 69
- Operation 69
- 3.2 Indicators 70
- Preliminary Configuration 71
- System Configuration 71
- Routine Management 72
- Autobaud Function 74
- 3.4 Turning Off the Unit 75
- Configuration 77
- Starting a Control Session 78
- Configure the SNMP Agent 80
- Ending the Control Session 81
- Command Syntax 81
- What to Do If … 82
- Ending a Control Session 83
- Command Options 84
- Index of Commands 84
- Chapter 5 87
- Configuring FCD-E1LC for 87
- Chapter 3 88
- 5.2 Configuration Example 88
- Configure System Timing 92
- Chapter 6 93
- Troubleshooting and 93
- 6.2 Detecting Errors 96
- 6.3 Handling Alarms 96
- Alarm Display 97
- Alarm Messages 97
- FCD-E1LC Ver. 1.0 100
- 6.4 Troubleshooting 103
- Appendix B 104
- Allowed Loopback 105
- Combinations 105
- Troubleshooting Procedure 106
- 6.5 Testing the Unit 108
- Local FCD-E1LC 109
- Remote FCD-E1LC 110
- BER Testing (LP BERT ML) 112
- Sublink Loopbacks 113
- Data Channel Loopbacks 115
- 6.7 Technical Support 121
- Appendix A 123
- Connection Data 123
- Figure A-2 124
- A.2 Sublink Connection Data 125
- Pin 13 Pin 1 126
- DCE Mode 127
- DTE1 Mode 128
- DTE2 Mode 129
- X.21 Data Channel 133
- Figure A-9 138
- Connector Data 140
- Connector 141
- Table A-15 141
- A.7 Power Connection 142
- SNMP Management 143
- SNMP Operations 144
- MIB Structure 144
- SNMP Communities 145
- B.2 SNMP Traps 146
- Appendix C 149
- Operating Environment 149
- G732N Multiframe 150
- G732S Multiframe 150
- E1 Line Signal 151
- Timeslot 0 151
- E1 Line Alarm Conditions 152
- C.2 IP Environment 153
- (13 bits) 154
- IP Address Structure 155
- Host Portion 156
- Subnetting 157
- Subnet Masks 157
- IP Routing Principles 158
- Ethernet LAN Topologies 159
- Media Access Method 160
- Autonegotiation 161
- Figure A-4 162
- Bridging 163
- ARP Protocol 165
- Appendix D 167
- Supervision Terminal 167
- Commands 167
- D.2 Commands 168
- Purpose 169
- <Enter> to continue 170
- DEF ALM MASK 171
- Chapter 4 172
- DEF BERT ML 174
- DEF CALL 176
- Table D-3 177
- Use – Serial Data Channel 179
- Use – Ethernet Port 185
- DEF DNLOAD 186
- DEF MANAGER LIST 189
- DEF NAME 192
- DEF NODE 192
- DEF PROMPT 192
- DEF PWD 193
- DEF ROUTE 194
- Table D-8 195
- DEF SYS 202
- DEF TERM 203
- DSP AGENT 204
- DSP ALM 204
- DSP BERT ML 205
- DSP HDR TST 206
- DSP MANAGER LIST 207
- DSP PM ML 207
- DSP PM SL 210
- DSP REM AGENT 210
- DSP ST CH 211
- DSP ST ML 212
- DSP ST SL 214
- DSP ST SYS 214
- INIT DB 217
- Syntax & Use 220
- Customer Response Form 223
- Error Report 225
- International Headquarters 228
- North America Headquarters 228
Verwandte Produkte und Handbücher für Vernetzung RAD Data comm FCD-V35
Vernetzung RAD Data comm FCD-IP Bedienungsanleitung
(110 Seiten)
(110 Seiten)
Vernetzung RAD Data comm FOM-T3 Spezifikationen
(42 Seiten)
(42 Seiten)
Vernetzung RAD Data comm Optimux-106 Spezifikationen
(110 Seiten)
(110 Seiten)
Vernetzung RAD Data comm ASM-20 Spezifikationen
(116 Seiten)
(116 Seiten)
Vernetzung RAD Data comm T1 Spezifikationen
(34 Seiten)
(34 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.034 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern