RAD Data comm FCD-V35 Spezifikationen Seite 199
- Seite / 228
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-33
SPEED STOP_BITS PARITY INTERFACE CTS DCD_DEL
DSR
AUTO 8 NO DCE =RTS 0 MS
ON
2. Change the parameter values by bringing the cursor to the beginning of the
field to be changed using the spacebar, and then press <F> or <B> to scroll
among the available selections. When the desired selection is displayed, press
the spacebar to move to the next field.
3. When done, press <Enter> to display the second row of the supervisory port
parameters data form. A typical display is shown below.
POP_ALM PWD LOG_OFF CALL_OUT_TRIGER ACTIVATE_CALL_OUT
AUXILIARY_DEVICE
NO NO NO NONE ANY CASE
TERMINAL
4. After the desired parameter values are selected, press <Enter> to end, and
then press <Enter> to reconnect to the FCD-E1LC.
Table D-9. Supervisory Port Configuration Parameters
Parameter Function Values Configuration Guidelines
SPEED
Selects supervisory
port data rate.
1200, 2400, 4800, 9600,
19200, 38400, 57600,
115200 – Supervisory port data
rates in bps
AUTO – Autobaud operation.
Default: 19200 or AUTO
Select AUTO in order for the
FCD-E1LC to automatically
identify the incoming traffic
data rate. In this case, to
enable positive identification of
the data rate, each connection
to the supervisory port must
start with three consecutive
<Enter>.
Do not use AUTO when the
CONTROL DCE port is
configured to use the SLIP or
PPP protocol: in this case, you
may lose the communication
with the FCD-E1LC and you
may have to reload the
factory-default parameters.
STOP_BITS
Selects the number
of stop bits in the
CONTROL DCE port
word format
1, 2 – Number of data bits
Default: 1
The supervisory port word
format should be the same as
on the terminal.
PARITY
Controls the use of
parity
ODD – Odd parity.
EVEN – Even parity.
NONE – Parity disabled.
Default: NONE
The supervisory port word
format should be the same as
on the terminal.
- FCD-E1LC 1
- Limited Warranty 4
- Product Disposal 4
- General Safety Instructions 5
- Safety Symbols 5
- Handling Energized Products 6
- Caution 8
- Attention 8
- FCC-15 User Information 9
- Mise au rebut du produit 10
- Symboles de sécurité 10
- Français 11
- Declaration of Conformity 13
- Quick Start Guide 15
- 3. Cable Connections 16
- Configuration Procedure 17
- Contents 19
- Chapter 1 21
- Introduction 21
- Main Features 22
- 1.2 Typical Applications 23
- 1.3 Physical Description 24
- 1.4 Functional Description 25
- Internal Bus Functions 27
- Main Link Interface 28
- Sublink Interface 29
- Synchronous Data Channels 30
- Ethernet Interface 31
- Ethernet Switch Description 32
- Flow Control Options 32
- Forwarding Algorithms 33
- VLAN and QoS Support 33
- System Timing 34
- Main Link Timing 34
- Sublink Timing 34
- Diagnostics 35
- Timeslot Handling 36
- Management Subsystem 36
- Power Supply Subsystem 38
- 1.5 Timing Considerations 39
- System Management Method 40
- Management Access Options 41
- Serial Ports 42
- MBE/RAS/A 42
- Diagnostics 48
- Indicators 48
- Chapter 2 51
- Installation and Setup 51
- Physical Requirements 53
- Power Requirements 53
- Connections 53
- Serial Data Port Connections 54
- Ethernet Port Connections 54
- 2.3 Package Contents 55
- 2.4 Equipment Needed 56
- 2.5 FCD-E1LC Enclosures 56
- FCD-E1LC Rear Panels 57
- Opening the Unit 60
- Figure 2-4 61
- Figure 2-5 61
- 1. Refer to 62
- Table 2-4 63
- Closing the Unit 64
- 2.7 Connecting the Cables 65
- Connecting the Sublink 66
- Connecting the Data Channels 66
- Connecting Ethernet 66
- 2.8 Connecting to Power 67
- Chapter 3 69
- Operation 69
- 3.2 Indicators 70
- Preliminary Configuration 71
- System Configuration 71
- Routine Management 72
- Autobaud Function 74
- 3.4 Turning Off the Unit 75
- Configuration 77
- Starting a Control Session 78
- Configure the SNMP Agent 80
- Ending the Control Session 81
- Command Syntax 81
- What to Do If … 82
- Ending a Control Session 83
- Command Options 84
- Index of Commands 84
- Chapter 5 87
- Configuring FCD-E1LC for 87
- Chapter 3 88
- 5.2 Configuration Example 88
- Configure System Timing 92
- Chapter 6 93
- Troubleshooting and 93
- 6.2 Detecting Errors 96
- 6.3 Handling Alarms 96
- Alarm Display 97
- Alarm Messages 97
- FCD-E1LC Ver. 1.0 100
- 6.4 Troubleshooting 103
- Appendix B 104
- Allowed Loopback 105
- Combinations 105
- Troubleshooting Procedure 106
- 6.5 Testing the Unit 108
- Local FCD-E1LC 109
- Remote FCD-E1LC 110
- BER Testing (LP BERT ML) 112
- Sublink Loopbacks 113
- Data Channel Loopbacks 115
- 6.7 Technical Support 121
- Appendix A 123
- Connection Data 123
- Figure A-2 124
- A.2 Sublink Connection Data 125
- Pin 13 Pin 1 126
- DCE Mode 127
- DTE1 Mode 128
- DTE2 Mode 129
- X.21 Data Channel 133
- Figure A-9 138
- Connector Data 140
- Connector 141
- Table A-15 141
- A.7 Power Connection 142
- SNMP Management 143
- SNMP Operations 144
- MIB Structure 144
- SNMP Communities 145
- B.2 SNMP Traps 146
- Appendix C 149
- Operating Environment 149
- G732N Multiframe 150
- G732S Multiframe 150
- E1 Line Signal 151
- Timeslot 0 151
- E1 Line Alarm Conditions 152
- C.2 IP Environment 153
- (13 bits) 154
- IP Address Structure 155
- Host Portion 156
- Subnetting 157
- Subnet Masks 157
- IP Routing Principles 158
- Ethernet LAN Topologies 159
- Media Access Method 160
- Autonegotiation 161
- Figure A-4 162
- Bridging 163
- ARP Protocol 165
- Appendix D 167
- Supervision Terminal 167
- Commands 167
- D.2 Commands 168
- Purpose 169
- <Enter> to continue 170
- DEF ALM MASK 171
- Chapter 4 172
- DEF BERT ML 174
- DEF CALL 176
- Table D-3 177
- Use – Serial Data Channel 179
- Use – Ethernet Port 185
- DEF DNLOAD 186
- DEF MANAGER LIST 189
- DEF NAME 192
- DEF NODE 192
- DEF PROMPT 192
- DEF PWD 193
- DEF ROUTE 194
- Table D-8 195
- DEF SYS 202
- DEF TERM 203
- DSP AGENT 204
- DSP ALM 204
- DSP BERT ML 205
- DSP HDR TST 206
- DSP MANAGER LIST 207
- DSP PM ML 207
- DSP PM SL 210
- DSP REM AGENT 210
- DSP ST CH 211
- DSP ST ML 212
- DSP ST SL 214
- DSP ST SYS 214
- INIT DB 217
- Syntax & Use 220
- Customer Response Form 223
- Error Report 225
- International Headquarters 228
- North America Headquarters 228
Verwandte Produkte und Handbücher für Vernetzung RAD Data comm FCD-V35
Vernetzung RAD Data comm FCD-IP Bedienungsanleitung
(110 Seiten)
(110 Seiten)
Vernetzung RAD Data comm FOM-T3 Spezifikationen
(42 Seiten)
(42 Seiten)
Vernetzung RAD Data comm Optimux-106 Spezifikationen
(110 Seiten)
(110 Seiten)
Vernetzung RAD Data comm ASM-20 Spezifikationen
(116 Seiten)
(116 Seiten)
Vernetzung RAD Data comm T1 Spezifikationen
(34 Seiten)
(34 Seiten)
AT&T SPIRIT 308 manuali
Manuali dei proprietari e guide per l'utente per Telefoni AT&T SPIRIT 308.
We fornisce 1 manuali pdf AT&T SPIRIT 308 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
At t SPIRIT 308 Manuale Utente (44 pagine)
Marchio: At-t | Categoria: Telephones | Dimensione: 0.49 MB |
Indice
AT&T
1
Answer Calls
14
Place Calls
16
Conference
20
Transfer
23
Line Reserve
26
SpeedCall
34
Dial Codes
41
999-500-237
44
Più prodotti e manuali per Telefoni AT&T
| Modelli | Tipo di Documento |
|---|---|
| EL51110 |
Manuale Utente
51110-001,
2 pagine
|
| 3658B |
Manuale Utente
Expansion Handset 5800/5806 [da] [de] [en] [es] [fr] [it] [nl] [sv] ,
8 pagine
|
| 7407D |
Guida Utente
AT&T 7407D User`s guide [en] [fr] ,
46 pagine
|
| CL84252 |
Manuale Utente
2 Handset Corded/Cordless Answering System,
1 pagine
|
| ATT1080 |
Manuale Utente
ATT1080 AWS McD Special Venue Form_v2,
2 pagine
|
| CL81201 |
Manuale Utente
1558 T 1558 1532 •••,
1 pagine
|
| CL82464 |
Manuale Utente
AT&T CL82464 User`s manual,
119 pagine
|
| TL86103 |
Manuale Utente
AT&T TL86103 User`s manual [en] ,
35 pagine
|
| EL52409 |
Manuale Utente
AT&T EL52409 CA CIB,
73 pagine
|
| E5812 | Manuale Utente 114416-2003 - SV http://ted.publications.eu.int/udl?REQUEST=Seek, 3 pagine |
| DECT EL51359 |
Manuale Utente
51359 Spec Sheet,
1 pagine
|
| 1412 |
Manuale Utente
AT&T EL52x00 CA QSG,
33 pagine
|
| 958 |
Manuale Utente
AT&T 958 User`s manual,
22 pagine
|
| TRIMLINE 210 |
Manuale Utente
AT&T TRIMLINE 210 User`s manual,
12 pagine
|
| CL82201 |
Manuale Utente
AT&T CL82201 User`s manual [en] ,
55 pagine
|
| DECT TL91378 |
Manuale Utente
AT&T DECT TL91378 User`s manual,
88 pagine
|
| E580-1 |
Manuale Utente
AT&T E580-1 User manual,
9 pagine
|
| TL86103 |
Manuale Utente
AT&T TL86103 User`s manual,
2 pagine
|
| MERLIN LEGEND Release 3.1 Calling Group |
Specifiche
AT&T MERLIN LEGEND Release 3.1 Calling Group Specifications,
159 pagine
|
| EL51110 |
Manuale Utente
AT&T EL51110 User`s manual,
28 pagine
|
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern