RAD Data comm ASMi-52 Technical Information PDF herunterladen (Seite 66)

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual

3-34 Repeater Level – Configuration Menu

Configuring the Repeater Parameters

The Parameters command enables you to configure the repeater parameters.



To configure the repeater parameters:

1. At the repeater level, select Configuration > Parameters…

2. Configure the desired parameters and click <Set>.

Figure 3-33. Repeater Parameters Dialog Box{need new graphic}

Table 3-25. Repeater Parameters

Parameter Possible Values / Remarks

Repeater

1…8

Wiring

2 Wire, 4 Wire

Loop Attenuation

Threshold (dB)

Unchecked (Loop Attenuation Threshold disabled),

Checked (Loop Attenuation Threshold enabled)

1…127

Note: This field is read-write when the SHDSL Mode is STU-C and read-only when the

SHDSL Mode is STU-R

SNR Margin

Threshold (dB)

Unchecked (SNR Margin Threshold disabled),

Checked (SNR Margin Threshold enabled)

1…15

Note: This field is read-write when the SHDSL Mode is STU-C and read-only when the

SHDSL Mode is STU-R

[Set] Click <Set> to set the repeater configuration parameters

[Cancel] Click <Close> to close the Repeater Parameters dialog box

[Refresh] Click <Refresh> to update the Repeater Parameters dialog box

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 99 100

Keine Kommentare

RAD Data comm ASMi-52 Technical Information Seite 66