RAD Data comm ACE-3600 Bedienungshandbuch PDF herunterladen (Seite 43)

Power Supply Module and Backup Battery

3-13

3) Remove the old battery from the RTU.

4) Check the replacement battery visually. If the battery looks deformed, if you notice

corrosion on the battery terminals, or the battery leaks, DO NOT use the replacement

battery; get another replacement battery.

5) Check the replacement battery terminal voltage level before connecting it. If the

battery voltage is less than 10V DC, DO NOT use the battery and replace it.

6) If the replacement battery passed the visual inspection and the terminal voltage is

satisfactory, put the battery into place on the RTU and screw in the battery holders.

7) Connect the battery cable to the battery terminals in the correct polarity.

8) Connect the battery cable to the Battery In/Out connector on the front panel of the

power supply module.

9) Recharge the replacement battery for 10 hours to be fully charged.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 163 164

Keine Kommentare

RAD Data comm ACE-3600 Bedienungshandbuch Seite 43