RAD Data comm Optimux-106 Spezifikationen PDF herunterladen (Seite 38)

Chapter 2 Installation and Setup Installation and Operation Manual

2-4 Connecting the Interfaces Optimux-106 Ver. 6.1

Connector Location

The following figures show the typical Optimux-106 rear panels. Connector pin

allocations appear in

Appendix A

Figure

2-1 Plastic Enclosure, Ethernet User Port and Unbalanced T1 Tributaries

Figure

2-2. Plastic Enclosure, Ethernet User Port and Balanced T1 Tributaries

Figure

2-3 Metal Enclosure, Ethernet User Port and Unbalanced T1 Tributaries

Figure

2-4. Metal Enclosure, Ethernet User Port and Balanced T1 Tributaries

Connecting to Channels

The tributary interfaces include four RJ-45 connectors.

³ To connect the tributary connectors:

• Connect each of the tributary cables to the RJ-45 connector(s) designated

CH1, CH2, CH3, or CH4, respectively.

Connecting to Ethernet Network

The User Ethernet port includes one RJ-45 connector used to connect to the

Ethernet network equipment.

³ To connect to the Ethernet network equipment:

1. Connect the RJ-45 Ethernet cable to the Ethernet network equipment.

2. Connect the other side of the RJ-45 Ethernet cable to the USER-ETH port.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 109 110

Keine Kommentare

RAD Data comm Optimux-106 Spezifikationen Seite 38