RAD Data comm MiRICi-E3T3 Spezifikationen PDF herunterladen (Seite 20)

Quick Start Guide Configuring MiRICi-E3T3

4 Connecting MiRICi-E3T3 to the Host MiRICi-E3T3 Ver. 2.2

2. Connecting MiRICi-E3T3 to the Host

You do not have to switch off the host unit when inserting or extracting the

MiRICi-E3T3 device.

³ To insert MiRICi-E3T3:

1. Set the DIP switches on MiRICi-E3T3’s underside to enable normal working

mode (see

Figure 1

2. Plug MiRICi-E3T3 into a free SFP (MSA-compatible) socket of the host device.

Make sure that MiRICi-E3T3 is pressed firmly into the MSA SFP port connector.

The device is ready to operate once the LOS LED has blinked three times.

When MiRICi-E3T3 is inserted into the host, the LOS LED blinks three times if the

device is in normal or CONFIG mode; or blinks continuously if the device is in INIT

DB mode. The LOS LED stays OFF if the device is in SW Dwnld mode.

³ To connect to the E3/T3:

• Use the miniature BNC cables (included in the MiRICi-E3T3 package) to

connect MiRICi-E3T3 to the coaxial E3/T3 line.

³ To eject MiRICi-E3T3:

1. Disconnect cables attached to MiRICi-E3T3.

2. Push the release button on the front of MiRICi-E3T3. This extracts the device

from the edge connector.

3. Remove MiRICi-E3T3 from the socket.

Note

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 105 106

Keine Kommentare

RAD Data comm MiRICi-E3T3 Spezifikationen Seite 20